上海士锋生物科技有限公司
中级会员 | 第14年

13127537090

标准品
培养基
培养基原料 霍乱弧菌诊断血清 大肠艾希氏菌诊断血清 志贺氏菌属诊断血清 沙门氏菌属诊断血清 标准血清,诊断血清 抗生素药敏纸片 微生物配套试剂 微生物生化管 管装培养基 即用型液体培养基 一次性培养基平板 显色培养基 临床培养基 菌种保存培养基 四环素检定、厌氧亚硫酸盐还原杆菌检测培养基 维生素检测培养基 一次性卫生用品卫生检测培养基 罐头食品商业无菌检测培养基 饮用水及水源检测培养基 药品、生物制品检测培养基 化妆品检测培养基 动物细胞培养基 啤酒检验培养基 军团菌检测培养基 支原体检测培养基 小肠结肠炎耶尔森氏菌检验培养基 弯曲杆菌检验培养基 产气荚膜梭菌、肉毒梭菌、厌氧菌检验培养基 阪崎肠杆菌检验培养基 溶血性链球菌检测培养基 李斯特氏菌检测培养基 弧菌检测培养基 乳酸菌、双歧杆菌检测培养基 酵母、霉菌检测培养基 检测培养基 沙门氏菌、志贺氏菌检验培养基 大肠菌群、粪大肠菌群、大肠杆菌及肠杆菌科检测培养基 细菌总数检测,增菌培养基
抗体
生物试剂
细胞
菌株
血清
细胞分离试剂
试剂盒

牛牛天天人人综合影院 士锋生物ELISA(酶联免疫吸附试验)

时间:2014/1/9阅读:778
分享:

Reagents:
PBS (pH 7.3) Coating Solution: 0.1 M Sodium Carbonate (pH9.6) with 0.02% Sodium Azide Wash Solution: 0.9% NaCl-0.05% Tween 20 (NaCl/T) PBS-TA: PBS-Tween 20 (0.05%) - sodium azide (0.02%) pH 7.3 AP Substrate Buffer: 0.05 M sodium carbonate-0.001 M MgCl2 (pH 9.3) HRP Substrate: Mix equal parts TMB peroxidase substrate and TMB peroxidase soln B. Notes: 1. Sodium Azide cannot be used in conjunction with HRP conjugates. 2. Wash cycles are critical steps to eliminate background.
Protocol:
1. antigen (5-20 µg/ml) in coating buffer is added to plastic tubes or microtiter plates (currently in use are Linbro plates or Costar serocluster "U" vinyl plates #2797). Incubate for 4 hours at 37°C and then store at 4°C until use (if less than two weeks). For the vinyl plates, wash three times with washing solution, dispel liquid by slapping on paper towels and then cover and store at -70°C. These plates are good for at least 6 months.
2. Wash tubes or plates with washing solution three times, waiting 10 minutes between washes. Make sure all wells are filled with wash solution during each wash cycle.
3. Block tubes or plates with 0.5% BSA for 1 hr by compley filling tubes or all wells.
4. Wash tubes or plates with washing solution four times, waiting 10-15 minutes.
5. Add 100µl of antisera diluted in PBS-TA to each well, incubate for 5 hours at RT or overnight in refrigerator. Normally a 1:100 dilution is sufficient. Monoclonal antibodies should be used undiluted.
6. Wash the plate as before and then add conjugate diluted with PBS-T(A). Incubate for 4 hours at RT for AP conjugates; 1.5 hours at RT or 1 hr at 37 C for HRP conjugates. Normally a 1:1000 dilution is sufficient.
7. Wash four times as before and then add 100 µl substrate to each well. For AP conjugates: Substrate solution is p - nitrophenyl phosphate (Sigma) at 1 mg/ml in substrate buffer. Allow the color to develop for 100 minutes and stop reaction by adding 10 µl of 1 N NaOH. Read absorbance at 405nm. For HRP conjugates: Mix equal parts of the TMB system, place in wells, allow to develop until desired intensity (app. 5 min) and stop reaction by adding 100 µl of 1M Phosphoric Acid. Read at 450 nm.
Conjugate Preparation
1. Centrifuge 0.3ml enzyme (alkaline phosphatase, Sigma type VII, sp act. 1,140 U/ml) at 8,000 x g for 2 mins.
2. Add to the pellet 0.1 ml specific antibody (animal specific, pathogen specific) affinity purified, resulting in a 3:1 ratio of enzyme to antibody.
3. Dialize overnight against PBS.
4. Add 10 µl of gluteraldehyde to a final concentration of 0.2%.
5. Incubate at RT for 2 H, dilute to 1ml, and dialize overnight against PBS.
6. Dilute to 10ml with 0.05 M Tris-5% BSA-1mM MgCl2-0.02% NaN3 .

会员登录

×

请输入账号

请输入密码

=

请输验证码

收藏该商铺

X
该信息已收藏!
标签:
保存成功

(空格分隔,最多3个,单个标签最多10个字符)

常用:

提示

X
您的留言已提交成功!我们将在第一时间回复您~
拨打电话
在线留言